![]() ![]() # cp /etc/netctl/examples/ ethernet-static /etc/netctlĪdjust the copy as needed, and enable it: Copy the required one to /etc/netctl, for example ethernet-static: Several example profiles, such as for configuring a static IP address, are available. For networks which require both a username and password, see WPA2 Enterprise#netctl. The resulting configuration file is stored in /etc/netctl. List available networks, and make a connection for a specified interface: They are prefixed with en (ethernet), wl (WLAN), or ww (WWAN). Interfaces can be listed using ip link, or iw dev for wireless devices. To prevent conflicts, stop the enabled dhcpcd service first, replacing enp0s25 with the correct wired interface: ![]() Otherwise, continue to #Update the system clock. If no connection is available, see Network configuration or follow the below netctl examples. Verify a connection was established, for example with ping. To access captive portal login forms, use the ELinks browser. The dhcpcd daemon is enabled on boot for wired devices, and will attempt to start a connection. # setfont lat9w-16 Connect to the Internet If certain characters appear as white squares or other symbols, change the console font. Note: localectl list-keymaps does not work due to bug FS#46725.įor example, to change the layout to de-latin1, run: Available choices can be listed with ls /usr/share/kbd/keymaps/**/*.map.gz. To verify you are booted in UEFI mode, check that the following directory is populated: In case you have a UEFI motherboard with UEFI mode enabled, the CD/USB will automatically launch Arch Linux via systemd-boot. ![]() For modifying or creating configuration files, typically in /etc, nano or vim are suggested. This guide assumes you use the latest available version.Īfter booting into the installation media, you will be automatically logged in as the root user and presented with a Zsh shell prompt. See Category:Getting and installing Arch for instructions on downloading the installation medium, and methods for booting it to the target machine(s). A basic installation with all packages from the base group should take less than 800 MB of disk space. Requires=network.target After=network.targetĮxecStart=/usr/bin/ethtool -s %i wol umbg Type=oneshotĪnd running ethtool -s enp6s0 wol umbg seems to work just fine.Arch Linux should run on any i686 compatible machine with a minimum of 256 MB RAM. Jan 25 17:53:45 stealth systemd: Failed to start Wake-on-LAN for enp6s0. Jan 25 17:53:45 stealth systemd: Failed with result 'exit-code'. Jan 25 17:53:45 stealth systemd: Main process exited, code=exited, status=75/TEMPFAIL Jan 25 17:53:45 stealth ethtool: netlink error: No such device Jan 25 17:53:45 stealth ethtool: netlink error: no device matches name (offset 24) Jan 25 17:53:45 stealth systemd: Starting Wake-on-LAN for enp6s0. Process: 440 ExecStart=/usr/bin/ethtool -s enp6s0 wol umbg (code=exited, status=75) Loaded: loaded enabled preset: disabled)Īctive: failed (Result: exit-code) since Wed 17:53:45 CET 22min ago I tried my best to follow the instructions on the wiki, but whenever I try to start the service using systemctl it does not work, and when I run sudo systemctl status I get the output × - Wake-on-LAN for enp6s0 I have for the past couple of hours been trying to get WoL to work on my computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |